Tuesday, October 25, 2016

building some trenches - still going ...

Two small end-pieces to be used with other sections for smaller setups...
 Used here with the finished basic build gun emplacement ...
 the long section gets a command bunker ...

waiting for Renedra sandbags to arrive and then once those are added will start adding filler etc...

Monday, October 24, 2016

Building some trenches - WIP

I've been building some trenches ....
The above photo shows three sections, two ends and a longer centre section. The trenches are made using some thick shelving board (aprox 2cm thick) cut up into suitable lengths, stuck to some thick cardboard. The sides of the trenches are thinner cardboard, any gaps have been filled up with foamboard and cork tile.

I will be adding another section to contain a gun,
 the aim is to have enough trench sections to go across the table, representing a section of a beach for an invasion landing. Trench sections should be usable on their own as well.

I'll need plenty of sandbags !

Tuesday, October 18, 2016

Hanomag (Sdkfz 251) - Canvas Covers

Being lazy about putting sitting figures in my Hanomag's I decided to give them canvas covers..

I made up some small cardboard pieces and used some plastic bits and other cardboard pieces suitable shaped to make the 'hoops' ....
 each cardboard piece was then covered in some thin brown curtain lining material...
 when fixed on the covers were given a splosh of PVA, and when this was dry a light wash of tan brown; a most pleasing result...

Wednesday, October 12, 2016

peremiter wire fencing made - WIP

All the fencing sections have now been made up  
the gate can be moved to an open position ...
enough fencing to enclose an area of 3ft x 2ft.

lots to paint !

Tuesday, October 11, 2016

Making some peremiter wire fencing - WIP

While on a 'make stuff' bender I decided to make up some perimeter fencing, a couple of lengths done ...
made using large cocktail sticks cut to size for the posts with plasterboard joint tape for the fencing.

Monday, October 10, 2016

Tank Traps and Barbed wire - WIP

a few bits accumulating for painting, some Italeri tank traps and home-made barbed wire
barbed wire is made by wrapping some copper wire round a bit of dowling and sticking to wire posts on a cardboard base.

Wednesday, October 5, 2016

renovating a Lysander ...

A nice Ebay buy for  £3.99, a poor distressed Airfix Lysander - wings not straight,  wheels on back to front, missing propeller blade and an interesting paint scheme. A bit of careful wiggling and use of a craft knife got the cockpit and wing off plus the wheel assemblies...
wheels back on, gaps filled, new propeller blade made using wire & green stuff, wing re-assembled and cockpit & crew painted...
the wing and struts were carefully stuck back on and then it was painted, I had to paint round the transfers which was bit tricky, and touched them in as needed.
 on its maiden flight (using a small stand intended for aircraft strafing runs)